Bambu PLA LW
Bambu PLA Aero has almost the same filament density as regular PLA, while the prints density is only 50% to 80%. Foaming PLA materials (PLA Aero) have high requirements for material drying and parameter settings.
Controllable Model Density : The relationship between the maximum foaming rate, minimum print density, and printing temperature of PLA Aero.
Compared to pre-foaming Wood PLA, Bambu PLA Aero and its prints are tougher and more resistant to impact, collision, and falling.
Printing recommendation:
Drying Settings (Blast Drying Oven) 55 °C，8 h
Printing and Keeping Container's Humidity < 20% RH (Sealed, with Desiccant)
Nozzle Temperature 220 - 260 °C
Bed Temperature (with Glue) 35 - 45 °C
Printing Speed < 180 mm/s
Foaming Rate 0 -120%
Print density 0.55 - 1.05 g/cm³
| : | PLA |
| Visual outlook of surface: | Matte |
| Printing difficulty: | Tapasztalatot igényel |
| Hardened nozzle: | no |
| Enclosed space: | no |
| Layer adhesion (subjective): | Bad, need attention to |
| Max. Print Speed (mm/s): | <200 mm/s |
| Shrinking (during printing): | Low (< 0,5%) |
| Max. Volumetric Speed: | not available |
| MFR - Melt Flow Rate: | Low (<10 g/10min) |
| Density: | 1,2 g/cccm |
| HDT - Heat Distortion: | Low (<80 C) |
| Max. Service Temp: | 53 ℃ |
| Chemical resistance: | exhibits high resistance to water, salts and oils, but it has limited resistance to strong acids and bases. |
| Elongation at break: | Small (<5%) |
| Max. Flexural Strength: | 41 - 50 MPa |
| Flexural Modulus (stiffness): | 1500 - 1999 MPa |
| Stress at break: | <30 MPa |
| Impact strength: | 21 - 30 kJ/m2 |
| UL94 complaint (V0- strictest): | no |
| ESD - Electrostatic Discharge: | no |
| FDA compliant: | yes, but no cert. |
| Toy Safe compliant (EC No 1272/2008): | no |
| RoHS compliant (2011/65/EU): | yes |
| REACH compliant (EC No 1907/2006): | yes |